Click Properties on the menu that pops up. Open Device ManagerĬlick the Windows Start button and then right-click Computer. Plug the Microcontroller Board into the PCĪfter plugging in the microcontroller (and powering it if externally powered), Windows will try to install a driver.Īutomatic driver installation will fail. or whatever save item your browser uses) Installing the Driver 1. (To save the above driver, right-click and choose Save Link As. It can also be downloaded here:Ītm6124_cdc.inf – Atmel Windows USB CDC driver The driver will be copied to the PC if the SAM-BA PC software is installed. When the Atmel ARM based board is plugged into a PC USB port, the driver makes the Atmel USB microcontroller configure as a USB CDC port that will appear as a COM port in Windows. This article shows how to install the driver in Windows 7 that the SAM-BA PC software uses. Microcontrollers that have a USB port and SAM-BA running can then be connected to a PC and programmed via a USB cable using the Microchip SAM-BA PC application. Once the SAM-BA boot software is loaded to Flash memory, the microcontroller will then run the SAM-BA software when powered up. AT91SAM7S256) ĪTSAM3U microcontrollers use the ERASE pin to load SAM-BA (e.g. Examples: AT91SAM7S uses the TST (TEST) pin to load SAM-BA (e.g.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |